城市环境总体规划中大气环境红线内涵及划定技术

城市环境总体规划是一项重大环境管理制度创新,目前全国已启动了24个城市的环境总体规划编制工作,其中划定环境红线是城市环境总体规划的核心内容。本文结合福州、宜昌、平潭等城市环境总体规划编制实践,首次提出了大气环境红线的技术框架,将大气环境红线划分为源头布局敏感区、污染易聚集区及敏感的环境受体三类,并创新性建立了大气环境红线划定技术方法,初步构建了适用于城市环境总体规划的空间规划技术体系。     

湿地基质及阴极面积对人工湿地型微生物燃料电池去除偶氮染料同步产电的影响

本研究采用人工湿地型微生物燃料电池处理偶氮染料X-3B,实现降解偶氮染料同步产电的效果.为了构建性能最优的人工湿地型微生物燃料电池(CW-MFC)系统,本研究主要从湿地基质和阴极面积两个方面研究系统构型对去除X-3B同步产电的影响,提高系统性能.研究表明以粒径10 mm、孔隙率30%的小石子作为湿地基质构造的CW-MFC系统微生物生物量最大,去除X-3B效果最好,脱色率高达92.70%,但其产电性能最差.较小的粒径和孔隙率使底层微生物生物量增加,促进X-3B的去除,但随着湿地基质粒径和孔隙率的减小,导致阴阳极营养物质不足,系统传质阻力增加,抑制了系统产电性能.X-3B的去除效果随着阴极面积的增加而提高直到阴极面积为594 cm~2时取得最大脱色率99.41%.当阴极面积继续增加时,CW-MFC系统产电性能上升趋势趋于平缓,X-3B去除效果呈现下降趋势,这是因为阴极反应过快导致更多的阳极电子输送到阴极用于产生电流,与X-3B发生反应的电子减少,阳极成为提高CW-MFC系统性能的限制因素.     

微生物燃料电池处理含S2-/NH4+废水的研究

以除硫硝化微生物燃料电池(Microbial Fuel Cell,MFC)处理含S~(2-)/NH_4~+的模拟无机废水,研究了不同进水S~(2-)浓度下MFC的产电性能、污染物去除效果和阳极室硫累积情况.结果表明,除硫硝化MFC可实现同步阳极除硫和阴极硝化,并通过非生物电化学作用和生物电化学作用共同产电.进水S~(2-)浓度为(60.8±2.9)、(131.7±2.4)、(161.7±4.5)和(198.1±3.1)mg·L~(-1)时,最佳阳极碳刷清洗周期分别为3、3、3、4个换水周期,前3个进水浓度下的换水周期可分别缩短为6、8和8 h.MFC阴极硝化完全,不受进水S~(2-)浓度影响,但氧从阴极向阳极的渗漏导致阳极库仑效率较低(40%).适当增加进水S~(2-)浓度可增强MFC的产电性能并提高S~(2-)去除负荷和颗粒硫累积比.除硫硝化MFC适宜的进水S~(2-)浓度为(161.7±4.5)mg·L~(-1),相应的最大功率密度为5.77 W·m~(-3),周期产电量为(141.0±5.2)C,S~(2-)去除负荷为(0.31±0.00)g·L~(-1)·d~(-1),颗粒硫累积比达58%.阳极碳纤维丝上沉积有粒径约100 nm的颗粒硫.阳极悬浮物与沉积物相比,悬浮物中S0含量比例较高,而S6+含量比例较低.     

桉树叶提取液还原石墨烯电极提高微生物燃料电池产电性能的研究

将桉树叶提取液绿色还原氧化石墨烯(G-rGO)电极和微生物还原氧化石墨烯(B-rGO)电极依次作为微生物燃料电池(MFC)阳极,采用红外光谱(FTIR)、X射线衍射(XRD)、扫描电镜(SEM)对所制备的电极进行表征,并采用循环伏安法(CV)、交流阻抗法(EIS)对比2种电极的电化学性能.结果发现,G-rGO阳极的内阻为243.87Ω,应用于MFC时最大功率密度和最大输出电压分别为18.77 W·m~(-3)和760 mV,对照组B-rGO电极的内阻为299.11Ω,将其应用于MFC时最大功率密度和最大输出电压分别为13.16 W·m~(-3)和635 mV,对照组未修饰阳极的内阻为375.21Ω,最大功率密度和最大输出电压分别为8.97 W·m~(-3)和480 mV.研究表明,G-rGO电极电阻更小,导电性能更优越.     

Direct methanol fuel cell bubble removal mechanism using magnetic actuation

This article develops a direct methanol fuel cell (DMFC) with a magnet-actuated bubble removal mechanism. A micro-DC motor is used to control the bubble removal mechanism. The lower magnetic device is operated to extrude a Polydimethylsiloxane (PDMS) runner to compress the liquid fuel in the anode flow channel, forcing the CO₂ bubbles in the runner to flow toward the outlet end. The bubble retention in the anode flow channel is thereby improved, enhancing the cell performance. The proposed mechanism stability and performance and Polymethylmethacrylate (PMMA) runner are also discussed.     

Some observations on copper yields and ore grades

The paper examines trends in the average copper content of mined ores over the years. It has tended to decline over the long term, but by no means evenly. US averages are not typical of global averages, at least in the past four decades. Those have been both higher, and less volatile than in the US. One reason for falling averages is a change in the type of deposit mined, with a rise in the share of relatively low grade porphyry deposits. The different nature of their deposits is reflected in marked differences in grades between the different continents. African and Australian average grades are higher than the global average, and changes in the share of Central Africa in global output have affected the global average grade. Yields are have been consistently lower in North America than elsewhere, and Latin American average grades have trended downwards, reflecting both the ageing of mines and the rising share of production from porphyry deposits. Typically the yield of mines declines over time as mining proceeds. The average copper content of ore deposits is usually below the average yield of the ore accessed in the early years of production. The initial grades of new mines have not declined over the past forty years, and there has been no perceptible tendency for the average grade of porphyry deposits brought into production to decline over time. There is no apparent correlation between average grade and deposit size, but mine operators tend to exploit economies of scale to offset low grades. The relationship between the annual percentage yields (the head grade) and the reserve grades of deposits is not static. In recent years head grades have fallen closer to reserve grades. The relationship may be affected by movements in metal prices. Although the evidence about the influence of prices is not clear-cut, it does suggest that prices and cut-off grades may be inversely related. As many ores contain other valuable metals besides copper, copper yields will sometimes be subordinated to the extraction of these other metals. Copper equivalent grades have not moved in the same way as copper grades alone.     

城市基本生态控制线划定范围研究

结合景观生态学原理,将城市基本生态控制线分解为基本农田控制线,河流与湿地控制线,林地控制线,山体控制线,海岸、沙滩控制线,针对每个景观生态要素控制线,通过定性、定量分析,分别提出划定依据、原则或方法。     

生物阴极式碳纸隔膜微生物燃料电池的反硝化和产电性能

为了探讨生物阴极式廉价隔膜微生物燃料电池(microbial fuel cell,MFC)的基本性能,首先以生物反硝化作用为基础构建了生物阴极MFC,并进一步以涂布聚四氟乙烯(PTFE)的廉价碳纸代替昂贵的质子交换膜(PEM)构建碳纸隔膜生物阴极式MFC。研究结果显示,对于生物阴极式MFC,阴极室中最适宜反硝化细菌生长的NO-3-N浓度为99.2 mg/L,此时输出电压最高可达0.11 V,1 h内NO-3-N的去除率达到80.0%,COD去除率为62.8%;以涂PTFE的碳纸代替PEM的生物阴极式MFC与有PEM的MFC最高输出电压基本一致(均达到0.22 V,外阻500Ω),但碳纸隔膜MFC的产电更稳定。结果验证了廉价隔膜生物阴极式MFC的可行性,并为其应用于污水脱氮奠定基础。     

电极移动速度效应检测仪系统的研究

分析了国际静电放电测试研究领域现有的各种测试研究装置特点，为克服已有测试装置缺陷本团队研发设计出一种全新的静电放电测试研究系统—电极移动速度效应检测仪。对其结构设计特点、功能进行了分析。我们研制的新型静电放电测试系统兼具实现真实直线运动准确调节和多环境因素可控的优点，彻底解决了困扰国际电磁兼容静电放电研究领域电极需高速向靶移动放电与避免强烈撞击损坏仪器的难题，实现了对多种因素影响逐一准确控制，为静电放电性质更为深入广泛的研究提供了新的手段和平台。     

马拉硫磷及其水解产物对圆瘤浮萍的生长抑制及氧化损伤作用

为了探讨马拉硫磷和主要水解产物对圆瘤浮萍的生长抑制作用及可能的氧化损伤机制,采用静态培养法,研究不同浓度的马拉硫磷及其水解产物二甲基二硫代磷酸酯(DMDTP)、二甲基硫代磷酸酯(DMTP)、二甲基磷酸酯(DMP)对圆瘤浮萍生长、叶绿素含量、叶绿体活性、超氧化物歧化酶(SOD)、过氧化物酶(POD)和过氧化氢酶(CAT)活性及丙二醛(MDA)含量的影响。结果表明,暴露7 d后,浓度为100 mg a.i.·L-1处理下的浮萍叶状体生长量与空白对照组无显著性差异;DMDTP、DMTP和DMP对圆瘤浮萍叶状体生长量的半数抑制浓度(7 d-IC50)分别为52.9、45.5和98.0 mg a.i.·L-1。随着试验液中DMDTP、DMTP和DMP浓度的升高,圆瘤浮萍叶绿素含量均明显降低,叶绿体活性则分别表现为诱导-抑制、抑制和抑制效应。在DMDTP、DMTP和DMP胁迫下,脂质过氧化产物丙二醛(MDA)含量明显增加;圆瘤浮萍体内的抗氧化酶系统均受到影响。总体表现为随着DMDTP浓度的增加,SOD活性先降低后升高;DMTP和DMP胁迫下,SOD活性呈现先降后升再降的趋势;POD和CAT活性则随3种水解产物浓度的增加呈现先升后降趋势;这表明抗氧化酶系统对外部胁迫的应答很复杂。马拉硫磷对圆瘤浮萍的毒性较小,其水解产物DMDTP、DMTP和DMP均对圆瘤浮萍的生长产生一定的毒性作用。在实际生产中,应多加关注马拉硫磷水解产物对环境生物的风险评估。